Girodiscs A1-100 380mm Lightweight 2-piece Rotor System is an upgrade replacement for the OEM brake discs. Girodisc rotors come with caliper carrier spacers to work with OE calipers. Upgrading your brakes with lightweight high performance replacements maintains the factory brake bias as well as the ABS efficiency. The Girodisc A1-100 380mm rotors weigh 22.6 lbs ea vs. 25.5 lbs ea for the stock 365mm units. This reduction in rotational and unsprung weight allows for quicker acceleration and suspension response. The rotor utilizes a curved vane design, developed in racing to act as a centrifugal pump to force cooling air through the disc.

Girodisc 2-piece brake rotors are a true directional rotor on both left and right sides (unlike the OEM rotors which have 1 side turning "backwards"), providing proper cooling under all situations. The larger 380mm slotted rotors provide more surface area and mass for cooling while still saving 3 Lbs of rotational and unsprung weight compared to the OEM rotors.

The rotor and hat have a floating mount system, which utilizes 10 drive pins. These pins take the load from braking actions while maintaining the axial and radial float between the hat and disc. The pins are secured by grade 12 cap screws with hardened washers. In order to keep the rotors from making noise when cold, the pins are mounted with anti-noise spring washers on the rotor side which allow the rotor to grow with heat expansion but eliminate the rattle and noise associated with floating rotors. This float also allows the rotor to self center between the pads.

Once the rotors are worn to the minimum thickness specification of 32mm, the rotor ring can be replaced separately from the hat at a reduced cost.

Girodisc A1-100 Brake Disc Vehicle Fitment:

• 2007-2008 Audi RS4  2007 Audi RS4  2008 Audi RS4 

Rotor Specifications:

• Diameter: 380mm
• Height: 46.6mm
• Thickness: 34mm
• Hat Thickness: 7.25mm
• Weight: 10.25Kg

Girodisc Brake Rotor Manufacturing:
The central hat section of the Girodisc rotor is made from strictly U.S. sourced 6061-T6 aircraft specification aluminum. The disc is made from Girodiscs own proprietary cast iron, poured in the USA and machined from start to finish in house at Girodisc. 10 high strength cadmium plated alloy steel drive pins along with grade 12 cap screws and hardened washers are used to attach the rotor to the hat.

Girodisc Rotor Installation:
Brake rotor installation typically takes about 30 minutes per rotor. Basic hand tools are necessary for installation. Please observe all safety precautions and follow proper installation guidelines while working on your vehicle.

Sold/priced per pair.